Laica ISEO Serie Manual De Usuario página 21

ACTIVATING THE CARTRIDGE REPLACEMENT INDICATOR
Carry out the following steps with the kettle off the power base.
1. Connect the power base plug to a power socket.
2. Press the button to switch on the device. Then press the
for about 3 seconds; the
lifetime of the filter cartridge and remains visible on the display for 30 days when the device is
connected to the power socket.
3. When the 30 days have elapsed, the
4. After activating the cartridge replacement indicator, pressing the
3 seconds will reset the remaining life of the cartridge; the
the display.
SETTINGS:
MEASUREMENT UNIT °C / °F
The water can be shown on the LCD display in degrees Celsius or Fahrenheit.
With the appliance on, press the "°F/°C" button; the measurement unit (°C or °F) will appear on
the display. Press the "°F/°C" button to change the measurement unit.
SILENT MODE
The appliance normally beeps whenever a button is pressed. It can be set to silent mode.
Switch on the appliance, press the
about 3 seconds; will appear on the display.
To activate the beep, press and hold the
Caution: when silent mode is set, the appliance beeps when boiling is finished or
when there is an alarm.
USING THE PRODUCT
NEVER connect the kettle to a power socket when it is empty.
DO NOT use the appliance for any purpose other than boiling drinking water.
Other liquids can contaminate the inside of the kettle.
DO NOT fill the kettle when the power base is already connected to the power
socket.
DO NOT fill the appliance above the MAX level mark. Overfilling may cause water
to spill out when it boils.
DO NOT attempt to connect other appliances to the power base, and do not
tamper with the connector in any way.
The kettle was designed to boil and filter at the same time. To ensure that the
appliance does not start heating when it is dry, wait a few minutes
before pressing the
the kettle up to the minimum (MIN) level. The kettle has an internal safety
cut-out that turns it off if there is not enough water when it is switched on. In this
case, disconnect the plug from the power socket and let the appliance cool down.
1. Place the power base of the kettle on a flat, dry, heat-resistant surface.
2. Open the kettle by removing the lid and fill it with water up to the maximum level ("MAX" mark
on the tank). Caution! To avoid damaging the heating element, there must be no less than
0.5 litres of filtered water, and it must not exceed the total capacity of 1.5 litres to prevent hot
EN
English
IT
Italiano
FR
Français
DE
Deutsch
ES
Español
symbol will appear on the display. This symbol indicates the
symbol will appear on the display.
button, then press the
button.
button to let the filtered water fill the bottom of
21
English
Italiano
Français
Deutsch
button and hold it down
Español
button again for about
symbol will disappear from
button and hold it down for
EN
IT
FR
DE
ES