Velleman WIFIR1 Manual Del Usuario página 5

included RJ45 cable (see 6.a.), or
wirelessly (see 6.b.).
Caution: if you have already configured the WIFIR1 as a repeater
but you want to change it to AP, you have to reset the device and
start the configuration again.
6. Configuration
a. Configuring Repeater Mode Using the RJ45 Cable
a1. Plug the WIFIR1 into a wall socket and connect it to your pc
using the included RJ45 cable.
a2. On your pc, click the Start button and choose Control Panel
> Network & Sharing Center.
In the list of networks, click on your network and then click the
Properties button.
In the list, select Internet Protocol Version 4 (TCP/IPv4),
then click the Properties button.
a3. In the Properties window, select Use the Following
IP Address. In the IP Address box, type 192.168.10.x where
V. 01 – 24/07/2013
WIFIR1
5 ©Velleman nv