Lithonia Lighting OFL1 LED THK Guía De Paso-A-Paso página 4

ACCESSORIES (sold separately)
Tenon Slipfitter (DSXF1/2TS) for use with OFL1 THK :
Attach the Tenon Slipfi tter (sold separately) to fi xture's threaded 1/2"
knuckle. Secure to the top end of a 1-1/4" to 2" pipe by tightening set
screws to 12ft-lbs and secure with locknut. Note: Seal arm thread using
Tefl on tape or silicone sealant.
2-1/2"
Vandalguard (polycarbonate shield)
To install vandalguard, unscrew the (2) 10-24 socket head screws on
the front face of the bezel and remove bezel. Replace glass lens with
vandalguard and re-install bezel. Note: do not touch LED
bezel
screw (2)
lens
Wireguard
To install wireguard, unscrew the (2) 10-24 socket head screws on the
front face of the bezel and remove bezel. Insert Wireguard and re-install
bezel. Note: do not remove glass or touch LED
OLF1 THK
1/2-14 NPS
DSXF1/2TS
5/16-18 NPT
(3 places)
TROUBLE SHOOTING GUIDE
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off.
To Ground fi xture use Wire Nut to connect the (copper) house supply
ground wire & the (green) fi xture ground wire. Note: If house wiring
does not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over
wires and twist clockwise until tight.
To connect supply wires use Wire Nuts to connect the black fi xture wire
to the black power supply wire and the white fi xture wire to the white
(neutral) supply wire.
Trouble Shooing Guide
If this fi xture fails to operate properly, use the guide below to diagnose
and correct the problem.
• Verify that power is turned on at switch and breaker
• Verify that fi xture is wired properly
• Verify that line voltage is correct
If further assistance is required, contact:
Technical Support at: (800) 279-8041
Cleaning and Maintenance
Caution: Be sure fi xture temperature is cool enough to touch. Do not
clean or maintain while fi xture is energized.
This LED light provides low maintenance service with no bulbs to
change. Clean surfaces with mild soap and water. Do not use abrasive
materials such as scouring pads or powders, steel wool or abrasive paper.
Do not touch LED.
Driver Access
The driver is pre-wired so access to the driver during installation is
uncessary but in case of a driver failure the driver can be accessed
and replaced. To access the driver compartment, unscrew the (4) 8-32
socket head screws in the back of the housing and remove the bezel and
heatsink assembly.
One Lithonia Way, Conyers, GA 30012
Acuity Brands Lighting, Inc.
www.AcuityBrands.com