Publicidad
Idiomas disponibles
Idiomas disponibles
Q&A (continued)
Q
The
A
The
on the cuff.
Therefore, it may not indicate motions (bending an arm slightly, etc.) that do not affect the cuff.
If you are concerned about the result, retry the measurement.
Troubleshooting
Display
The indication disappears in the
middle of the operation. (the
mark is displayed.)
is displayed.
Your arm or body moved.
Pressurization to more than
280 mmHg was performed. (Cuff
pressurizes several times.)
is displayed.
Pressure decreased suddenly.
Cuff does not inflate.
The measurement is not possible
though the cuff inflates.
Cuff pressurizes several times.
Failure of the main unit
is displayed.
BU35.indb
24
indicator does not light when an arm is moved.
indicator is a function to notify you that your arm is bent or to indicate extra loads
Status before error
APPENDIX
Cause and solution
Batteries are exhausted. (See page 10.)
Has the unit detected movement? (See
page 15.)
Were measurements taken
according to the proper procedure and in
the correct posture? (See page 13.)
●
Is the cuff wrapped properly?
●
Is the cuff plug inserted correctly into
the socket?
(See page 12.)
Take it to the store where it was purchased
for testing and repairs.
24
2011/06/14
14:28:30
Publicidad
