DeWalt DC800 Manual De Instrucciones página 12

Anvil With Detent Pin (Fig. 4)
DC800, DC810
A CAUTION: Use only impact accessorires. Non-impact accessories
may break and cause a hazardous condition. Inspect accessory prior
to use to ensure that it contains no cracks.
Place the switch in the locked off (center) position or remove battery
pack before changing accessories.
To install an accessory on the anvil, FIG.4
align the hole in the side of the accessory F
with the detent pin (E) on the anvil (F).
Press the accessory on until the detent
pin engages in the hole. Depression of
detent pin may be necessary to aid
installation of accessory.
To remove an accessory, depress the
detent pin through the hole and pull the
E
accessory off.
Quick-Release Chuck
(Fig. 5)
DC815
NOTE: The chuck accepts 1/4" (6.35 mm) hex accessories only.
Place the switch in the locked off (center) position or remove battery
pack before changing accessories.
To install an accessory, pull the chuck collar (H) away from the front
of the tool, insert the accessory and release the collar. The accessory
is locked in place.
To remove an accessory, pull the chuck collar away from the front
of the tool. Remove the accessory and release the collar.
FIG.5
H _lllllllllllln_
Usage
i_CAUTION: Ensure fastener and/or system will withstand the
level of torque generated by the tool. Excessive torque may cause
breakage and possible personal injury.
1. Place the accessory on the fastener head. Keep the tool pointed
straight at the fastener.
2. Press switch to start operation. Always check torque with a
torque wrench, as the fastening torque is affected by many
factors including the following:
• Voltage: Low voltage, due to a nearly discharged battery, will
reduce fastening torque.
• Accessory size: Failure to use the correct accessory size will
cause a reduction in fastening torque.
• Bolt Size: Larger bolt diameters generally require higher
fastening torque. Fastening torque will also vary according to
length, grade, and torque coefficient.
• Bolt: Ensure that all threads are free of rust and other debris to
allow proper fastening torque
11