Maintaining your appliance
Draining
When a steam function is complete, you must drain the remaining water to prevent
the water from affecting other cooking modes.
To drain the water, follow these steps:
1.
Touch Drain.
The oven drains water from the steam generator to the water reservoir.
2.
When draining is complete open the oven door, and then touch Reservoir
The oven ejects the water reservoir. Use oven gloves to remove and empty the
water reservoir.
3.
When done, re-insert the reservoir, push it in until there is a soft click, and
then touch Reservoir
. The oven retracts the reservoir.
4.
Close the oven door.
Care and cleaning of the oven
Cleaning painted parts and decorative trim
•
For general cleaning, use a cloth with hot, soapy water.
•
For more difficult residue and built-up grease, apply a liquid detergent directly
onto the area and leave for 30 to 60 minutes. Wipe with a damp cloth and dry.
Do not use abrasive cleaners on any oven surface. They can be scratched.
Cleaning stainless steel surfaces
1.
Shake a bottle of Stainless Steel Appliance Cleaner or Polish well.
2.
Place a small amount of stainless steel appliance cleaner or polish on a damp
cloth or damp paper towel.
3.
Clean a small area, rubbing with the grain of the stainless steel if applicable.
Dry and buff with a clean, dry paper towel or soft cloth.
4.
5.
Repeat as necessary.
NOTE
•
Do not use a steel-wool pad. It will scratch the surface.
•
If a mineral oil-based stainless steel appliance cleaner has been used before to
clean the appliance, wash the surface with dishwashing liquid and water prior
to using the Stainless Steel Appliance Cleaner or Polish.
40 English
NV51K6650DS_DG68-00854A-03_EN+MES+CFR.indb 40
Oven racks
•
If the racks are left in the oven during a self-cleaning cycle, their color will
turn slightly blue and the finish will be dull. After the self-cleaning cycle is
complete and the oven has cooled, rub the sides of the racks with wax paper
or a cloth containing a small amount of oil. This will help the racks glide more
easily on their tracks.
•
Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool.
.
During cleaning, be careful not to allow water or cleaner to enter the slides on
the sides of rack.
NOTE
•
Do not clean in a dishwasher.
If the rack becomes hard to remove or replace, lightly wipe the oven rack
•
guides with cooking oil. Do not wipe cooking oil on the slides.
•
If the rack becomes difficult to slide, the rack may need to be lubricated using
a graphite lubricant.
NOTE
•
To order graphite lubricant., call Samsung customer care at 1-800-SAMSUNG
(726-7864) or visit our homepage (www.samsung.com/us/support, www.
samsung.com/ca/support, or www.samsung.com/ca_fr/support) and search for
part number DG81-01629A.
•
If you want to buy directly, go to http://www.samsungparts.com.
To lubricate the slides of the gliding rack
1.
Remove the rack from the oven. See
removing the gliding rack in the USING
THE GLIDING RACK section.
2.
Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
2018-08-29
1:04:31