Installation Of Batteries; Basic Operation; Setting Of Standby Mode; Selection Of Input Mode - Nevir NVR-7406-32HD-N Manual De Instrucciones

LED COLOR TV

1.6 Installation of Batteries

(Here is only the sketch, please in kind prevail)

2. Basic Operation

2.1 Setting of Standby Mode

- Press ( ) button to turn on the unit.
- Press ( ) button again to return the display to standby mode. The
power indicator turns red.
- Be sure not to set your TV in standby mode for a long period of time.

2.2 Selection of Input Mode

This set has different signal source modes, you may continue to press the
Source button to select a signal source.
1 Open the back lid of the remote control.
2 Install two 7#(AAA)1.5V batteries.
Ensure the correct polarity of the batteries.
3 Cover the back lid.
Please take out of the batteries from the remote
control for long time of no use.
If the remote control doesn't work properly,
please carry out the following checks.
- Check the TV is turned on.
- Check the polarity of the batteries are correct.
- Check the batteries are not drained.
- Check the power supply is normal or the power cord
is correctly connected.
- Check there are no special fluorescent light or neon
light around.
5