Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
ii
:
Were measurements
> Eel Aioni to more nan
>
taken according to the
Remeasure mark
EN
i
proper procedure and | J»
E is displayed
in the correct posture?
IS
alepayed:
Pressure decreased suddenly | >
See p. 12 and 13.
» | and the remeasure mark E
appeared
Was the pressurization
»
Measurement was taken to
cuff wrapped properly?
20mmHg and then the
>
See p. 12.
remeasure mark £ appeared.
>
If proble
continu
The heart mark ¥ blinked only
a few times or not at all.
>
>
Tube may not be
connected sufficiently.
>
Check the tube
connection.
Pressurization doesn't occur
P| even after waiting several
dozen seconds.
+ Position of pressure cuff is low.
+ Pressure cuff is not wrapped correctly.
* Position of pressure cuff is high.
+ You moved or talked while measurements
were being taken.
See p. 12 and 13.
See p. 12.
Systolic or diastolic blood
pressure value is high or low.
Blood pressure value is
>
abnormally high or low.
Value is different from that >| Blood pressure varies in response to minute
measured by the doctor.
changes in your mental state, such as your
-
reaction to a doctor's presence.
Measurement values are differ- | | . Sit quietly for 4 to 5 minutes and then take
ent with each measurement.
another measurement.
S
.13.
No display appears even when
>
the On/Off Start button is pressed.
Ask
your
doctor
for
advice.
If problem
continues.
* Batteries are exhausted.
* Batteries are installed with the polarities
When the On/Off Start button was
wrong.
pressed, all displays became lit
and then the display disappeared.
Instrument isibraken:
>
Take it to the store where it was
4
'
purchased for testing and repairs.
4
See p. 10.
Publicidad
