Publicidad
Idiomas disponibles
Idiomas disponibles
FILTER REPLACEMENT
REPLACE FILTER LIGHT
The replace filter light illuminates when it is time to replace the
True HEPA filter based on the air purifier's hours of use.
REPLACING THE TRUE HEPA FILTER
For optimal performance, replace every 12 months under normal
usage conditions.
1. Unplug the air purifier. Pull the
indents on each side of the grille
cover.
2. Remove the grille cover and set
aside.
3. Pull the tabs to remove the old
filter.
4. With the filter tabs facing outward,
insert the new True HEPA filter.
5. Place the tabs at the bottom
of the grille cover into the
base of the air purifier. Gently
push the grille cover until it
snaps into place.
6. Plug the power cord into a standard
AC outlet and press the power
button Press and hold the ioniser
ION button for 3 seconds to reset
the indicator.
UV-C BULB REPLACEMENT
REPLACING THE UV-C BULB
The UV-C bulb is designed to last for approximately 10,000 hours
of use. The UV-C button on the control panel will flash RED when
the UV-C bulb burns out and needs to be replaced. The UV-C button
will change to blue once the bulb has been replaced.
NOTE: The air purifier will continue to operate without the UV-C
function when the UV-C bulb burns out.
CAUTION: Do not operate the air purifier without the
protective UV-C bulb cover.
CAUTION: Unplug the power cord before servicing or
replacing the UV-C bulb.
NOTE: The UV-C bulb contains mercury (Hg).
GB
4
I
1. Unplug the air purifier and remove
the True HEPA filter. Using a
Phillips-head screwdriver (not
included), unscrew the 2 screws
located on the UV-C bulb cover.
2. Remove the cover to expose the
UV-C bulb.
3. Gently push from the sides and
rotate the UV-C bulb to remove.
4. Remove and replace the UV-C bulb.
Re-install the UV-C bulb cover,
True HEPA filter, and grille cover.
Publicidad
