N'oveen CH5000 Turbo Fan Manual De Instrucciones página 11

2. Fan switch
3. Thermostat knob
CH-5000/CH-6000 also incorporates an internal fan, which can be switched on independent
of the heating elements.
Fan Operation: This is operated by means of the switch with the fan symbol along side it.
The fan will only operate with the thermostat in the "ON" position and can be used when the
heating elements are "ON" to blow warm air into the room.
In warm conditions the fan can be used with the heating elements "OFF" to blow cool air
into the room.
CH-6000 is equipped with a 24-hour clock that has 96 segments, each segment
corresponds to 15 minutes of time. With this timer you can set the time and duration of the
period (s) where the radiator will operate in any period of 24 hours.
Timer Operation (CH-6000 only)
The centre of the timer has a 3 position slide switch.
In the central position (denoted by the clock symbol) the timer will switch the heater on and
off at times set by the segments, (see setting the timer below).
The position denoted by the "T", is a timer override position. The timer will continue to run
but power will be fed continuously to the heater. This enables the heater to be on all the
time if required.
In the position denoted by the "O"，the timer continues to run but no power is fed to the
heater.
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up
with the arrow pointer, i.e. if the time the timer is being set is 8 Pm, rotate the outer ring until
the number 20 is in line with the arrow pointer.
Set the time the heater is required to run by pulling the segments around the outer ring
forward appropriate to the running period (s) required.
When set, the heater will operate each day during the times programmed. Note, the heater
must always be plugged into a power socket, the element switches must be in the "on"
position and the thermostat must be suitably set to ensure the heater will come on.
If the heater is required to run continuously the slide switch on the timer should be set to the
"T" position.
If it is subsequently required to revert back to timer operation, the slide switch on the timer
11