Zeegma Ironee Manual De Usuario página 8

5. Set the steam control knob to the desired position, adjusting the amount
EN
of steam according to the type of fabric.
Note! Steam ironing is only possible at higher temperature settings. Other-
wise, water may leak from the machine.
STEAM EJECTION FUNCTION
1. Place the device in a horizontal position. Fill the water tank (see: Filling
the water tank). Place the device in a vertical position.
2. Set the temperature control knob to the "MAX" position.
3. Wait until the iron plate heats up and the light indicator turns blue.
4. Press the steam ejection button (B, fig. A). Pressing the button several
times beforehand may be necessary to prepare the machine for operation.
5. Wait a few seconds for the steam to penetrate the fabric before pressing
the button again. For maximum efficiency, it is recommended not to use this
function more than three times in a row after the light indicator turns blue.
The steam ejection function is particularly helpful in removing stubborn
creases. It can be used for both steam and dry ironing.
ANTI CALC SYSTEM
Anti Calc is a system located inside the water tank that eliminates im-
purities from the water and reduces the problems of scale accumulation.
To prolong the effectiveness of this system, perform the following steps
periodically:
1. Unplug the iron from the power supply and let it cool down.
2. Fill the water refill container to about ¾ of its capacity. Add 1 teaspoon
of salt to the water and fill the water tank with the prepared solution.
3. Leave the solution in the water tank for 15 minutes, shaking it gently from
time to time, and then pour out the solution.
4. Fill the water tank a second time with the salt water solution, shaking it
occasionally, and empty it again after 15 minutes.
5. Fill the tank with fresh water to rinse it, and then pour out the water.
ANTI DRIP SYSTEM
Anti Drip is a system that constantly controls the flow of water to the iron
plate. Below a certain temperature, the anti drip function interrupts the
water flow and prevents water from dripping onto the fabric.
CORDLESS IRONING
To use the device in the cordless version, press the wireless base button (L,
Figure A), and then remove the device from the base.