Publicidad
Idiomas disponibles
Idiomas disponibles
6. Insert each leg onto a leg frame by depressing the pushpins (Figure
3A and 3B). Slide the leg frames over the leg and setting to the same
desired height (Figure 3C).
Adjusting Leg Height
1. On each leg, depress the push button
and slide to desired height by aligning
with a hole (Figure 3B).
Let the push button snap into a hole
to lock the leg in place (Figure 3C).
2. Check that the legs are locked in place
by pushing down and pulling up on
each leg.
3. Ensure all legs are at the same height.
Cautions
• To ensure the safe assembly and operation of this product, these
instructions must be followed. FAILURE TO FOLLOW INSTRUCTIONS
MAY RESULT IN SERIOUS INJURY TO THE USER OR DAMAGE TO THE
PRODUCT. If you are unable to understand these warnings, cautions
and/or instructions, contact a healthcare professional, dealer or
Medline before attempting to use this product.
• DO NOT assemble and use this product without first reading and
understanding this user's guide, otherwise injury or damage may occur.
• Users with limited physical strength and/or mobility should be
supervised and/or assisted while using the product. Prior to use, ensure
the following:
• Inspect all parts for possible damage before assembling. If there is any
damage – DO NOT USE. Contact Medline at 1-800-MEDLINE.
• Check that the height adjusting pushbuttons fully protrude through the
same corresponding hole of each leg extension. This ensures that the
leg extensions are securely locked in place at an even height.
• Make sure all screws, nuts and bolts are tightened.
• Verify that all tips are in place on the leg extensions and not ripped,
worn or missing. Replace any missing or damaged tips.
• The tips of all four leg extensions MUST touch the floor simultaneously
at all times.
• Ensure the chair remains balanced. Excessive twisting or turning while
seated on the chair may cause a loss of balance and/or damage to
the product.
• User evenly distributes weight between the side supports when
transferring in and out of the chair.
• DO NOT stand on the bath seat.
• DO NOT exceed the user weight capacity of 400 lb (181 kg).
• DO NOT place bath seat on uneven surfaces.
• DO NOT use if wobbly, unstable or not level.
• DO NOT make any adjustments while using the product.
• DO NOT use product for anything other than its intended use.
G2-201KRX1 (PIC-00303) | V2 092123
Figure 3
3
Publicidad
