Descargar Imprimir esta página

camry CR 5018 Manual De Uso página 4

Publicidad

19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
20. If you do not use iron, even for a short time, turn off the options of steam
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Use self-cleaning function at least once a month.
24. Iron must be used at a stable even surface and this can only be disposed of.
25. Do not fill the water tank with chemicals, perfumes or descaling substance.
DESCRIPTION OF DEVICE
A. Spray nozzle
C. Steam Control Lever
E. "Steam blast" button
G. Rotary cable gland
I. Thermostat knob - temperature control
K. Water tank
ANTI-CALC function
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin filter is permanent and
does not need replacing.
PLEASE NOTE: Use tap water only. Distilled and/demineralised water makes the "Zero-Calc" anti-calc system ineffective by altering its
physicochemical characteristics.
ANTI-DRIP SYSTEM
The plate may cool down to the point where no more steam comes out, but rather drops of boiling water that can leave marks or stains.
Self-Clean Function
It is recommended that you periodically use the soleplate Self-Clean function which prevents scale build-up in your iron. In order to do this,
fill your iron entirely with water, sit it on its heel, connect to the mains and set the thermostat to "MAX". When the control light goes out,
disconnect the device from the mains and hold it in a horizontal position, e.g. over a sink. Press the Self-Clean button (J) and hold the iron
for about a minute, shaking it. When it cools down, clean the soleplate with a moist cloth to remove any dirt.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight minutes in the upright position or unused for approx. Thirty
seconds in the horizontal position. warning sounds will arise that shut off has tripped.
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics. This is
quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
B. The water inlet hole
D. Spray button
F. Power Cord
H. Thermostat indicator light
J. Self-clean button
L. Ceramic soleplate
FABRIC
TYPE
synthetic
silk - wool
Cotton - linen
Fabric not to be ironed
ENGLISH
4
THERMOSTAT
REGULATION
·
low temperature
··
medium temperature
···
high temperature

Publicidad

loading