Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

IB50507322
Installation Instructions – Sure-Lites SELRA50 / SELRA50SD
Recessed Emergency Light
Instructions d'installation – Lampe d'urgence encastrée série
Sure-Lites SELRA50 / SELRA50SD
Instrucciones de instalación: Luz de emergencia empotrada de la
serie SELRA50/SELRA50SD de Sure-Lites
Important Safeguards
Read and follow all safety instructions
WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions carefully before installing or
maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations.
All service shall be performed by qualified service electrician. This product must be installed and maintained in accordance with the
applicable installation codes by a person familiar with the construction & operation of the product and the hazards involved.
This product must be installed in accordance with the applicable installation codes and ordinances.
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
Disconnect AC power and unplug battery before servicing.
Consult your local building code for approved wiring and installation.
Do not let power supply cord touch hot surfaces.
Do not mount near gas or electric heater.
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
Connect to an AC voltage as recommended on the product label of this equipment.
Risk of Fire, Electrical Shock or other Casualty Hazards- Installation and maintenance of this product must be performed
by a qualified electrician. This product must be installed in accordance with the applicable installation code by a person
familiar with the construction and operation of the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance.
Disconnect power at fuse or circuit breaker.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the
improper, careless, or negligent installation, handling or use of this product.
Note: Specifications and dimensions subject to change without notice.
NOTICE: Fixture may become damaged and/or unstable if not installed properly.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on delivery receipt. File claim
for common carrier (LTL) directly with carrier. Claims for concealed damage must be filed within 15 days of delivery. All damaged
material, complete with original packing must be retained.
WARNING
Sure-Lites

Publicidad

loading

Resumen de contenidos para Cooper Lighting Solutions SELRA50 Serie

  • Página 1 Risk of Personal Injury- Due to sharp edges, handle with care. DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the improper, careless, or negligent installation, handling or use of this product.
  • Página 2 If needed, replace the round trim plate with the rectangular trim plate included. Slide the complete assembly up and into the Back Box (Figure H). Secure the assembly to the Back Box using the screws provided. Make necessary adjustments to the lamp heads ori- entation at this time (Figure I). COOPER LIGHTING SOLUTIONS IB50507322 Installation Instructions...
  • Página 3 Installation Instructions – Sure-Lites SELRA50 / SELRA50SD Recessed Emergency Light FIGURE A FIGURE B FIGURE C FIGURE D FIGURE E FIGURE F FIGURE G FIGURE H FIGURE I COOPER LIGHTING SOLUTIONS IB50507322 Installation Instructions...
  • Página 4 Push test button and hold for 6 seconds System reset (While in test mode) Warning: a) Make sure that power is OFF before making any electrical connections. b) Unused wires must be capped using enclosed wire nuts. COOPER LIGHTING SOLUTIONS IB50507322 Installation Instructions...
  • Página 5 Risque de blessures – à cause des arêtes tranchantes, manipulez ce produit avec précaution. EXONÉRATION DE RESPONSABILITÉ : Cooper Lighting Solutions n’assume aucune responsabilité pour les dommages ou pertes de quelque nature que ce soit pouvant découler d’une installation, d’une manipulation ou d’une utilisation inappropriée, imprudente ou négligente de ce produit.
  • Página 6 (figure H). Fixez l’ensemble à la boîte arrière à l'aide des vis fournies. Effectuez les ajustements nécessaires à l'orientation des têtes de lampe à ce moment-là (Figure I). COOPER LIGHTING SOLUTIONS IB50507322 Instructions d’installation...
  • Página 7 Instructions d’installation – Lampe d’urgence encastrée série Sure-Lites SELRA50 / SELRA50SD FIGURE A FIGURE B FIGURE C FIGURE D FIGURE E FIGURE F FIGURE G FIGURE H FIGURE I COOPER LIGHTING SOLUTIONS IB50507322 Instructions d’installation...
  • Página 8 6 secondes (en mode test) Avertissement : a) Assurez-vous que l'appareil est hors tension avant d'effectuer toute connexion électrique. b) Les fils inutilisés doivent être bouchés à l'aide des écrous de fil fournis. COOPER LIGHTING SOLUTIONS IB50507322 Instructions d’installation...
  • Página 9 Riesgo de lesiones personales: debido a los bordes afilados, manejar con cuidado. EXENCIÓN DE RESPONSABILIDAD: Cooper Lighting Solutions no asume ninguna responsabilidad por daños o pérdidas de ningún tipo que puedan surgir de la instalación, el manejo o el uso incorrectos, descuidados o negligentes de este producto.
  • Página 10 (Figura H). Fije la unidad a la caja trasera con los tornillos suministrados. Realice los ajustes necesarios en la orientación de las lámparas en este momento (Figura I). COOPER LIGHTING SOLUTIONS IB50507322 Instrucciones de instalación...
  • Página 11 Instrucciones de instalación: Luz de emergencia empotrada de la serie SELRA50/SELRA50SD de Sure-Lites FIGURA A FIGURA B FIGURA C FIGURA D FIGURA E FIGURA F FIGURA G FIGURA H FIGURA I COOPER LIGHTING SOLUTIONS IB50507322 Instrucciones de instalación...
  • Página 12 Advertencia: a) Asegúrese de que la alimentación está desconectada antes de realizar cualquier conexión eléctrica. b) Los cables que no se utilicen deben finalizarse con las tuercas para cables incluidas. COOPER LIGHTING SOLUTIONS IB50507322 Instrucciones de instalación...
  • Página 13 Veuillez consulter le site www.cooperlighting.com pour obtenir les conditions générales. Garantías y Limitación de Responsabilidad Visite www.cooperlighting.com para conocer nuestros términos y condiciones. Cooper Lighting Solutions 1121 Highway 74 South Cooper Lighting Solutions is a registered trademark. Peachtree City, GA 30269 P: 770-486-4800 All trademarks are property www.cooperlighting.com...

Este manual también es adecuado para:

Selra50sd serie