Warning And Precautions; Definitions - Num'axes VIS1012 Instrucciones De Uso

Warning and precautions

Your Digital Night Vision device was designed to provide many years of reliable service. To ensure that you get the most enjoyment out of your Digital Night Vision device, always obey the
following warnings and precautions.

Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, this device incorporates sophisticated digital circuitry which could be damaged in
extreme cases of misuse.

Do not open the body of the device or otherwise attempt to service this device.

Never pour alcohol or any other liquids directly onto the lens surfaces.

Do not clean lenses and unit surfaces with paper based products, such as newspaper, textbook paper, etc. as it can damage the coating.

Avoid removing the eyepiece as the LCD display could become damaged.

Do not leave the device in direct sunlight, high humidity conditions (higher than 70 %) or rain. The unit is water resistant, but is not designed for prolonged exposure to moisture
and cannot be submerged in water.

Always store the unit in its carrying case in a dry well ventilated space in temperature above +15°C (60° F).

Do not store near heating devices. After the unit is operated in temperatures below zero, wait at least 3 hours at room temperature, to avoid condensation accumulating on the
internal lens surfaces and the consequent fogging caused by extreme temperature differences.

Remove the batteries if the device will not be used for longer than a few weeks.

Definitions


Infrared LED illuminator: enables clear viewing in low ambient light conditions or even total darkness.

LCD display: displays the images with the setting and status.

Objective: captures the image/video.

« + » and « - » Buttons: allow you to adjust the magnification of digital zoom.

Battery Tray: container to install 4 pieces AA alkaline batteries (not supplied).
The following item are located on the bottom of the unit:

Video out Port (jack): allows you to connect the unit, using the video cable supplied, to a video monitor or recorder to remotely view or record the image from the night vision unit.

MicroSD Card Slot: where to install the MicroSD memory card (not supplied). The night vision supplied accepts SD memory cards up to 32GB.
G : Video output jack.
H : USB port.
I : MicroSD card slot.
J : Photo/video switch.
21/65