Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ASSEMBLY INSTRUCTIONS
Insert the front fork into the
Before assembly, remove the plastic
main frame tube
covers from both front and rear wheel axis.
bending of the fork faces forward.
Handlebar and front fork
Place the upper headset ring
installation: remove the sleeve
and the sleeve
cover, the sleeve itself and upper
front fork.
the headset ring from the front
fork. At installation, the headset
composition must be as on the
picture.
Seat installation: put the seat
Adjustment of brake levers
(only for FIFTY B): incline the
tube into the frame
(1)
of the
running bike, adjust the desired
brake levers correctly by loose-
ning the screw on the sleeve (1).
height (do not exceed the ma-
ximum mark) and tighten the
sleeve screw (2).
on the running bike, hold the handles and
stretch out your fingers in a way that his/her
Then inflate the tires according
arm and the fingers form a single straight
to the values on their side (ideally
line. This should be the position of the
brake lever.
between 1,3 and 1,8 bars).
18
18
Place the sleeve screw exactly on
(1)
so that the
the cut-out of the fork tube as on
the picture.
(2)
(3)
back on the
Adjustment of brake: when
braking, check that the brake
pads fit tightly on the rim sides.
Their position can be adjusted via
the screws (1). The pads shall not
The right inclination: let the child sit
touch the tires.
Put the sleeve cover
(1)
on the
In the end, place the protective
handlebar tube and place it into
cover over the sleeve.
the fork tube (2). Adjust the heigh
as desired (do not exceed the
maximum mark) and tighten the
screw on the sleeve (3).
Check that the pads make enou-
In case the brake pad is touching
gh space (1-2 mm) after releasing
the wheel when turning, symmet-
the brake levers. The distance
rically adjust the distance of brake
can be adjusted by tightening or
arms by the tightening screws (3).
loosening the brake cable at the
anchor screw (2).
Protective pad installation:
place the soft protective pad
from washable nylon over the
handlebar stem.
Bend the ending of the brake
cable so that it does not obstract
when the child is riding.
19
19
Publicidad
