Publicidad
Idiomas disponibles
Idiomas disponibles
GB
To set the stamp wheels Fig.
Press the handle
travel and keep holding it.
Press and hold button
Allow the handle
the handle locks in place.
You will be able to move the stamp wheels
freely with the stylus
You can hide preceding zeros in a number!
(Not valid for the stamp Model CK.)
Example:
49
Turn the stamp wheel
digit position "0".
Using stylus
rotate and push down on
stamp wheel
through a half digit position
until it sinks below print height.
To return to the print position, simply push
down on handle
Any wheel which has been 'sunk' will auto-
matically be brought to print height as the
numbering sequence progresses. 'Sunk' wheels
can be brought into play by simply rotating
them further (ie. push towards figure 1.).
To insert the inkpad Fig.
Note: Use only oil-containing stamp ink.
Handle with caution to avoid dirt from ink!
Press the handle
travel and keep holding it.
Press the button
continue to hold it.
1
+
2
to the bottom of its
on the front plate.
to move upwards until
.
instead of
000049
with stylus
.
1
+
3
to the bottom of its
on the front plate and
Allow the handle
the handle locks in place.
Unpack the inkpad carefully.
Squeeze the grips
inkpad and hold them.
Insert the ink pad inside the pad cradle.
Slide the pad into the slot
In order to return to the print position,
simply push down on handle
To change the numbering actions Fig.
Actions
0
to
1
2
Raise the Action selector lever
it to the desired action.
To park the stamp Fig.
To prolong the life of the inkpad,
park the stamp!
Press and hold button
Gently push handle
stamp clicks & locks in a raised position.
In order to return to the print position,
simply push down on handle
to move upwards until
on the back of the
The same number is stamped every time.
Number increases after each stamping
process.
Number increases after every 2
stamping process.
etc.
downwards until the
GB
of the stamp.
.
4
nd
and move
5
on the front plate.
.
Publicidad
