Publicidad
Idiomas disponibles
Idiomas disponibles
6
GETTING STARTED
USB wall charger is not
standard accessory
with this
appliance.
Fill
Eject
Insert
Charging Unit Prior to First Use
Connect the USB charging cable to the unit (USB-C) and then to the USB wall charger (USB-A).
Then plug the USB wall charger into the power outlet and charge unit for approximately 4 hours.
Note: Refer to the IMPORTANT SAFEGUARDS section for required USB wall charger specifications.
Always ensure USB plugs and USB ports are clean and dry before connecting.
LED will glow as it charges. LED stays lit when fully charged until USB cable is unplugged from the device. LED blinks 8 times once you
are finished flossing and if the battery is below 30%.
NOTE: Make sure unit is dry before opening weathercap and connecting the charger.
Replace the weathercap after charging and ensure it's fully seated
(flush with the outside surface of the handle).
Filling the Reservoir
Before filling, disconnect charging cable and replace charging port cover.
Lift flip top on reservoir and fill with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. Press firmly until the tip clicks into place. To remove the tip
from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Publicidad
