Publicidad
Idiomas disponibles
Idiomas disponibles
9
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial solutions. For ease of adding other solutions remove
the reservoir (see "When Finished" section) and add from top opening on reservoir. If you are adding additional water you may replace
the reservoir and fill reservoir fully with the fill door. After using any special solution, rinse unit to prevent clogging by partially filling
reservoir with warm water and running unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Before cleaning, unplug from the electrical outlet. Clean the product when necessary by using a soft cloth
and mild non-abrasive cleanser to wipe exterior.
Remove
The water reservoir is removable for easy cleaning and is top rack dishwasher safe.
It is recommended that the reservoir is removed and cleaned weekly.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of your water. If left unattended, it can hinder
performance. Cleaning internal parts: add 1 tablespoon of white vinegar to a full reservoir of warm water. Point the handle and tip
into sink. Turn unit ON and run until reservoir is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Publicidad
