Descargar Imprimir esta página

Craftsman 139.30437 Manual Del Propietário página 17

Ocultar thumbs Ver también para 139.30437:

Publicidad

Idiomas disponibles

Idiomas disponibles

iNSTALLATiON
STEP
6
install the Lights
1. Press the releasetabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
2. Insert an A19 incandescent (lOOW maximum) or compact
fluorescent (26W, IOOW equivalent) light bulb into the light
socket. The lights will turn ONand remain lit for approximately
4-1/2 minutes when power is connected. Then the lights will
turn OFF.
3. Reversethe procedure to close the lens.
4. If the bulbs burn out prematurely due to vibration, replacewith
a garage door opener bulb. Use A19, standard neck garage
door opener for replacement.
NOTE:Do not use halogen, short neck, or specialty light bulbs as
these may overheat the end panel or light socket. Do not use LED
bulbs as they may reduce the range or performance of your
remote control(s).
To prevent possible OVERHEATING of the end panel or light
socket:
* Use ONLYA19 incandescent (IOOW maximum) or compact
fluorescent (26W maximum) light bulbs.
* DONOT use incandescent bulbs larger than IOOW.
* DONOT use compact fluorescent light bulbs larger than
26W (IOOW) equivalent.
* DONOT use halogen bulbs.
* DONOT use short neck or specialty light bulbs.
Release Tab
Compact Fluorescent --
Light Bulb
,/ 100Watt(Max)
Standard Light Bulb
!
100Watt(Max)
\
Standard Light Bulb
_
Hinge
Compact Fluorescent
Light Bulb
iNSTALLATiON
STEP
7
Attach the Emergency Release Rope and Handle
1. Insertoneend of the emergency releaseropethroughthe handle.
Makesurethat "NOTICE" i s right sideup.Tiea knotat least1 inch
(2.5 cm)from the endof the emergency releaserope.
2. insertthe otherend of the emergency releaseropethroughthe hole in
the trolley release arm. Mountthe emergency releasewithin reach,but
at least6 feet (1.83 m) abovethefloor, avoidingcontactwith vehicles
to preventaccidental r elease and securewith a knot.
NOTE:If it is necessary to cut the emergency release rope, seal
the cut end with a match or lighter to prevent unraveling. Ensure
the emergency release rope and handle are above the top of aft
vehicles to avoid entanglement.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garage door:
* If possible, use emergency release handle to disengage
trolley ONLYwhen garage door is CLOSED.Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
* NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
* NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Trolley
Trolle
Release
Arm
Emergency
Release Handle
Overhand
Knot
17

Publicidad

loading