Craftsman 139.30437 Manual Del Propietário página 19

Fastenthe Door Bracket(Continued)
ONE-PIECE DOORS
Please read and comply with the warnings and reinforcement
instructions on the previous page. They apply to one-piece doors
also.
* Center the door bracket on the top of the door, in line with the
header bracket as shown. Mark either the left and right, or the
top and bottom holes.
* Meta/Doors: Drill 3/16" pilot holes and fasten the bracket with
the 1/4"-14x5/8" self-threading screws provided.
* WoodDoors: Drift 5/16" holes and use 5/16"x2" carriage bolts,
lock washers and nuts (not provided) or 5/16"x1-1/2" lag
screws (not provided) depending on your installation needs.
NOTE: Thedoor bracket may be installed on the top edge of the
door if required for your installation. (Refer to the dotted line
optional placement drawing.)
HARDWARESHOWN
ACTUAL SIZE
Self-Threading Screw
1/4"-14x5/8"
Header Wall
Door
Bracket
2x4 Support
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
HORIZONTALAND VERTICAL
REINFORCEMENTIS NEEDED
FOR LIGHTWEIGHTGARAGE
DOORS(FIBERGLASS, ALUMINUM,
STEEL, DOORSWITH GLASS
PANEL, ETC.). (NOT PROVIDED)
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
_Self-Threading
Screw
" 1/4"-14x5/8"
Door
Bracket_
' _nside Garage)
................................. °o"0e
;;iil;il;!i:iiiiiiiiiiiiiiiiii_ii!:!!ii:ii_iii!i:!iii_!!_'
t_onal
Placement
METAL DOOR
Nut _ Lock
SJtB'-fB---¢ ¢-- Washer
, 5/16"
i
i
i
Door
Bracket _
_-- 5/16"x2"
(Not Provided)
WOOD DOOR
19