Publicidad
EN
This product requires two 1.5V AA batteries (Not Included).
Thank you for purchasing our Metal Detector. Please read this user's
manual carefully and thoroughly before operating this equipment.
Operating Instructions
● Adjusting Length
1. Loosen the stem's lock nut clockwise.
2. Extend the stem as the arrow. Then turn the stem's lock nut
counterclockwise to lock it.
3. Hold the metal detector to make the search coil above the ground
for about 1-5cm (0.4-2inch) and parallel to the ground. Then rotate
the Stem's lock nut counterclockwise to tighten it. The tightness of the
search coil can be adjusted by rotating the fixing knob. Do not
over-tighten stem's lock nut and the fixing knob.
08
Search Coil
Stem Lock Nut
Fixing Knob
Lower Stem
● Installing the battery
Your metal detector is powered by two AA batteries.
1. Open the battery cover in the direction of the arrow.
2. Buckle the battery after matching the polarity. Then place the
battery into the battery compartment.
Battery Cover
● Caution:
- Use only new battery of the required size;
- If you don't plan to use the unit for a week or more time, remove the
battery. The battery can leak chemicals that can destroy electronic
parts.
- Change the battery if the low battery indicator on the LCD lights.
Control Box
Handle
Upper Stem
09
Publicidad
