Publicidad
● Assembly of Detector
1. Insert the coil cable plug into 5 pin jack.
2. Secure nut on plug.
3. Insert the upper stem into the jack connected with the control box.
4. Secure with fixing knob.
5. Loosen the lock nut and lengthen the stem.
6. Tighten the lock nut counter clockwise.
10
Loosen the lock nut
Lengthen the stem
Tighten the lock nut
● Control panel
Power Switch
ON/OFF
● Operation
1. Press the power switch to turn on the detector. At this time, LCD
displays
which means the detector is ready for operation.
2. Hold the detector in a comfortable position with the search coil in
parallel with a flat surface where there is no metal objects.
3. Place a sample of coin on the ground, sweep the coil in a
side-to-side motion to find the sample. (Coins are not included)
4. During searching, LCD displays
metallic object, beep sounds will be heard and LCD displays
5. When LCD displays
, replace the battery.
● Hints for searching
1. The detector comes with motion detection mode. For finding metal
targets, you have to move the coil or move the metal sample above
the coil.
2. Sweep the search coil in a side-to-side motion.
. When the detector finds a
.
11
Publicidad
