Dvd Player Rear Panel; Setting Up Of The Dvd Player; Safety Instructions - Silvercrest KH 6520 Instrucciones De Uso

B. DVD player rear panel
S VIDEO
j
: S Video output
k AUDIO OUT L/R
: Left and right audio outputs
l EURO SCART
: Scart/RGB output
CENTER
; : Output for front and centre audio channels
SL/SR
2) : Output for rear, left and right audio channels
FL/FR
2! : Output for front, left and right audio channels
VGA:
2@
VGA video output
2# COAXIAL
: Coaxial audio output
2$
Power cable
OPTICAL
2% : optical digital audio output
HDMI
2^ : HDMI output
SUBWOOFER
2& : Output for bass audio channel
Y, PB/CB, PR/CR
2*
: Component video outputs
2( VIDEO
: Composite video output
C. Remote control
q OPEN/CLOSE
: Open/Close the disc tray
DIMMER
w : Adjust the display brightness
SKIP BACKWARDS (-)/FORWARDS (+)
e
r VOLUME +/-
: Volume increase/decrease
t CLR
: Clear the entry
y A-B
: Repeat sequence
u MODE
: Set the playback mode
STOP
i : Stop playback
PLAY/PAUSE
o
: Start/Suspend playback
a DVD/CARD/USB
: Change between disc playback and USB/card playback
s OK
: Confirm input
d
Control buttons
f ZOOM
: Set the image enlargement
SEARCH
g : Access the search function
ANGLE
h
: Change the camera perspective
j MUTE
: Switch the sound on/off
k MARK
: Access the bookmark function
l RGB
: Set the video signal to RGB
; YUV
: Set the video signal to YUV
2) Battery compartment (on the rear panel)
HDMI:
2!
Set the HDMI output
2@ VIDEO
: Set the video output
2# TITLE
: Access the title menu
2$ MENU
: Access disc menu
2% SUBTITLE
: Set the subtitle
AUDIO
2^ : Set the audio language/channel
DISPLAY
2&
: Superimpose disc information
2* SETUP
: Access the OSD menu
2( SLOW
: Slow motion function
3) F.RWD/F.FWD
: Fast scan backwards/forwards
3! PRG
: Access the programme function
3@ Number buttons
STANDBY
3#
: Switch the device to standby mode

5.Setting up of the DVD player

1.
Carefully remove the DVD player and the supplied accessories from the
packing.
2.
Remove the protective foil from the display.
3.
Place the DVD player on a flat, even and firm base.
Attention!
Do not plug the DVD player into an electrical outlet at this time. Wait
until you have connected the DVD player to a television set.
In the event that you wish to change the type of video or audio connection you
must first pull the power plug from the power socket! Otherwise
the DVD player and possibly equipment connected to it could become
irreparably damaged through voltage peak strikes!

6. Safety instructions

• This device is not intended for use by individuals (including children) with
restricted physical physiological or intellectual abilities or deficiences in
experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how
the device is to be used.
• Children should be supervised to ensure that they do not play with the
device.
• To avoid unintentionally switching on the device pull the power cord from
the mains supply after use and before cleaning.
• Check the device and all parts for visible damage. The safety concept can
work only if the device is in a faultless condition.
• The power plug must always be easily accessible, so that the device
can be quickly separated from the mains in the event of an emergency.
Risk of electrical shocks.
• Connect the device only to correctly installed and earthed mains sockets.
Ensure that the rating of the local power supply tallies completely with the
details given on the rating plate of the device.
• Arrange for defective power plugs and/or cables to be replaced at once
by qualified technicians or our Customer Service Department.
• Arrange for customer service to repair or replace connecting cables
and/or devices that are not functioning properly or have been damaged.
NEVER submerse the device in water. Wipe it only with a slightly damp
cloth.
• Do not expose the device to rain and never use it in a humid or wet
environment.
• Ensure that the power cable never becomes wet during operation.
• You must not open the housing or repair the device yourself. Should you
do so, device safety can no longer be assured and the warranty will
become void.
• Protect the device against drip and spray water. Do not place any water-
filled vessels (e.g. flower vases) on the device.
Risk of fire!
• Do not use the device in the vicinity of hot surfaces.
• Do not locate the device in places exposed to direct sunlight, If you do, it
may overheat and become irreparably damaged.
• Do not leave the device unattended when in use.
- 59 -