Bodypoint AS116L Manual De Instrucciones página 7

I N S TA L L I N G T H E A R M S U P P O R T
Prior to installation, remove the Quick-Release Receiver from the Arm Support.
information see: "USING THE QUICK-RELEASE ADAPTER PLATE."
1. Mount the Quick-Release Receiver to the wheelchair armrest using optional armrest mounting
hardware. Partially tighten the mounting screws to allow for adjustment. See instructions included
with optional mounting hardware for details.
3. Slide the Arm Support into the Quick-Release Adapter Plate—the Quick-Release Latch should
lock with an audible "click!"
Note: The Quick-Release
Latch can be adjusted
to remove any play by
loosening the M5 screws
(2) on the bottom using
a 3mm hex key. Push the
Quick-Release Latch tightly
against the back edge of
the Quick-Release Wedge
while retightening
screws to secure it in place.
A DJ U S T I N G T H E F O R E A R M PA D A N D H A N D B L O C K
Begin by positioning the user's elbow in the Elbow Pad.
To adjust the Hand Block, loosen the
M6 screws (2) and slide the Hand
Block along the Base Board to prevent
shifting of the user's forearm. Tighten
the rear screw until it is snug, then adjust
the angle of the Hand Block 0-30° to
properly position the hand and wrist.
Fully tighten both screws to secure the
Hand Block in place.
To adjust the Forearm Pad loosen the
M6 screws (2) and slide the Forearm
Pad along the Base Board to cradle the
user's arm behind the wrist. It can be
adjusted in or out, rotated, or reinstalled
in the opposite direction to support or
limit arm movement. Re-tighten the
screws.
the
For more
2. Mount the Hand Block
to the Base Board using
the Washer Plate and the
included M6 screws (2).
Note: Do not fully tighten
the screws until the final
adjustments have
made to fit the
been
user.