Descargar Imprimir esta página

M.J. MALLIS GROUP Siat SR46-S Manual De Instrucciones Y Recambios página 89

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

11-SET-UP AND ADJUSTMENTS
Keep the outer column with one hand and remove the four screws A
with the other hand; push the column up until it reaches the holes B.
Reassemble and tighten the four screws.
Put the pneumatic installation back into work.
11.12 AS77 CASTERS (OPTIONAL)
(code nr. 7.8.04337.00B)
To make easier the machine displacement, it is possible to fit the op-
tional casters. Doing this, the conveyor bed height and the machine
overall dimensions change (see section 4.7).
Lift the machine as shown on Picture.
Remove the pad-feet, insert the casters fixing them with the two dowels and
set the desired conveyor bed height (refer to the graduated leg label).
(Caster height = 100 mm-4 inch).
11.13 AS80 LEGS (OPTIONAL)
(Kit code nr. 7.8.04413.00A)
To obtain a higher range of conveyor bed height as indicated at section
4.7, it is necessary to replace the inner legs with the longer AS80 legs.
Uplift the machine as shown on Picture.
Unlock the screws and take out the legs.Insert the new legs and block
them at the desired height.
January 2007
89
ENGLISH

Publicidad

loading