XFARM xSense Mini Guía Rápida De Instalación página 12

Assembly and installation guide: accessories
xLeaf (foliar wetting sensor)
In case of xSense installation with xLeafs it
will be necessary to fix it to the pole with
the bracket and clamps provided.
Install sensor and wire at a minimum of 1 metre from the ground with the tip
pointing North and the raised part upwards.
Cleaning and Maintenance
The sensor must be cleaned periodically using a cloth moistened with just
water.
If the sensor is used in extremely sunny areas with unusually high radiation
loads, the application of McNett UV protection is recommended.
To apply McNett UV Technology:
• Clean the sensor with water and a clean, soft cloth.
• Spray a soft cloth with UV Tech spray.
• Wipe both sides of the sensor surface with a damp cloth to apply
protection
12