Publicidad
Idiomas disponibles
Idiomas disponibles
Muffler
fuel Cap
oil fill Cap
& Dipstick
Now that you have set up your tiller for operation, get acquainted with
its controls and features. These are described on the next two pages
and illustrated on this page. This knowledge will allow you to use your
new equipment to its fullest potential.
RECOIL STARTER HANDLE
This handle is used to start the engine.
THROTTLE CONTROL
The throttle control is located on the side of the engine. It regulates the
spread of the engine and will shut off the engine when moved into the
STOP position.
Craftsman Tillers conform to the safety standard of the American National Standards Institute (ANSI).
OPERATION
gear selection
Handle
Handle adjustment
lock
air filter
Meets ANSI Safety Standards
Figure 8
The operation of any tiller can result in foreign objects being thrown
into the eyes, which can damage your eyes severely. Always wear
safety glasses during operation or while performing any adjustments
or repairs.
CHOkE CONTROL
The choke control is found on the side of the engine and is activated
by moving the lever to the CHOKE position. Activating the choke
control closes the choke plate on the carburetor and aids in starting the
engine.
11
Clutch Control
Depth stake
rear tine shield
side shield
WARNINg
Publicidad
