Publicidad
Idiomas disponibles
Idiomas disponibles
To adjust the side shields, remove the wing nuts. Move the side shield
to the desired position and replace the wing nuts. Tighten securely.
See Figure 11.
ADjUSTINg THE HANDLE HEIgHT
The handle should be adjusted so that when the tiller is digging 3-4"
into the soil, the handle falls to about waste-high. To adjust handle,
simply unlock the Handle Adjustment Lock, then move the handle bars
to the desired position and then re-lock the Handle Adjustment Lock.
WARNINg
Before clearing the tines by hand, stop the engine, allow all moving
parts to stop and disconnect the spark plug wire. Failure to follow this
warning could result in personal injury.
CLEARINg THE TINES
•
The tines have a self-clearing action which eliminates most of the
tangling of debris. However, occasionally dry grass, stringy stalks
or tough vines may become tangled. Follow these procedures to
help avoid tangling and to clear the tines, if necessary.
•
To reduce tangling, set the depth regulator deep enough to get
maximum "chopping" action as the tines chop the material against
the ground. Also, try to till under crop residues or cover crops
while they are green, moist and tender.
•
While tilling, try swaying the handlebars from side to side (about
6" to 12"). This "fishtailing" action often clears the tines of debris.
WARNINg
Before tilling, contact your telephone or utilities company and inquire
if underground equipment or lines are used on your property. Do not
till near buried electric cables, telephone lines, pipes or hoses.
TILLINg TIPS & TECHNIQUES
Tilling Depth
•
This is a DDT (dual-direction tine) tiller. As the wheels pull
forward, the tines rotate backward. As the wheels pull rearward,
the tines rotate forward. This creates an "uppercut" tine action
which digs deeply, uprooting soil and weeds. Don't overload the
engine, but dig as deeply as possible on each pass On later
passes, the wheels may tend to spin in the soft dirt. Help them
along by lifting up slightly on the handlebar (one hand, palm up,
works most easily).
•
Avoid the temptation to push down on the handlebars in an
attempt to force the tiller to dig deeper. Doing so takes the weight
off the powered wheels, causing them to lose traction. Without
the wheels to hold the tiller back, the tines will attempt to propel
towards the operator or away from the operator.
OPERATION
•
When cultivating (breaking up the surface soil around the plants
to destroy weeds, See Figure 12), adjust the tines to dig only 1"
to 2" deep. Using the shallow tilling depth helps prevent injury to
the plants whose roots often grow close to the surface. If needed,
lift up on the handlebars slightly to prevent the tines from digging
too deeply. (Cultivating on a regular basis not only eliminates
weeds, it also loosens and aerates the soil for better moisture
absorption and faster plant growth.) Watering the garden area a
few days prior to tilling will make tilling easier, as will letting the
newly worked soil set for a day or two before making a final, deep
tilling pass.
shallow tilling
Position
15
side shields
wing nuts
Deep tilling position
Figure 11
Figure 12
Publicidad
