Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before assembling the product, make sure all parts are included. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged,
do not attempt to assemble the product.
Estimated Assembly Time: 10-15 minutes
Tools required for assembly and installation (not included):
3/8" (10 mm) Wrench
Phillips Screwdriver
Sealant Tape
Drill & 3/8" Drill Bit
Pencil
Level
ASSEMBLY INSTRUCTIONS
Find a piece paper to make a template of the
wall mount bracket (D). Place the paper over
the mounting bracket and mark the bolt holes of
the bracket. See figure 1.
1. Pick where you would like to hang the hose
reel. Tape the template on the wall.
2. Using the 3/8" drill bit, drill the 3 holes that
you marked on the template. See figure 2.
NOTE:
If drilling directly into wood then there is no need
to use the plastic anchors.
If drilling into dry wall or cement you will need to
insert the plastic anchors into the hole.
Insert anchors if needed, then screw 2 of the
mounting screws into the holes (upper one and
the lower one). Leave about 6 mm (1/4-in)
between the wall and screw head.
1
2
BB
5
AA
Publicidad
