Kobalt SGY-AIR265 Manual Del Usuario página 6

ASSEMBLY INSTRUCTIONS
3. Hang the hose reel on the 2 screws you
previously installed.
4. Push down on the mounting bracket until the
2 screws slide into the top of the top of the hole
in the bracket. See figure 3.
5. Tighten the 2 screws and then insert and
tighten the middle screw to finish locking the
bracket in place.
6. Pull out the hose to the desired length,
ensure the hose reel is locked (will not rewind)，
open the latch on the bumper (G) and move it
to the desired location. Re-latch the bumper (G).
See figure 4.
OPERATING INSTRUCTIONS
1. To extend air hose (B), slowly pull air hose to desired length. The hose reel will
make a "clicking" sound as the hose is pulled out. The clicking sound you hear is
the drum locking into place so it will not retract when you let go of the air hose. It
may be necessary to pull the air hose beyond desired length to keep it from
automatically retracting.
2. To retract, slowly pull air hose (B) until clicking stops. While holding the air hose,
let the hose automatically draw back until the bumper (I) stops against the hose
guide (H).
NOTE To avoid damaging the hose reel (A), always hold on to air hose (B) while it is
rewinding.
CARE AND MAINTENANCE
Always operate the product with care by following the operating instructions.
3
4
6
BB