Publicidad
Idiomas disponibles
Idiomas disponibles
1.INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by
removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national
electrical code requirements.
Supply for fan must be 110/120 volt, 60Hz. Maximum
fan motor amps: 1.0, Maximum light watts: 180
incandescent or ballast and LED.
Otherwise power can cause serious injury or death.
B. Installing receiver in fan:
a. Remove power from the circuit.
b. Remove ceiling fan canopy from the mounting
bracket.
c. Disconnect existing wiring between ceiling fan and
Supply in electrical junction box.
d. Make connections as follows, using the wire nuts
supplied:
FROM POWER SOURCE
AC 110~120 VOLT 60Hz
3.5AMPS.
ANT
Use wire connecting nuts
WHITE
supplied with the remote
controller.
WIRE NUT
If other fans or supply wires are different color, have this unit installed by qualified licensed electrician.
a.Push all connected wires up into junction box.
b.Lay the brown antenna wire on top of the receiver, and put the receiver into the mounting bracket.
c.Reinstall the canopy on the mounting bracket.
d.Restore power.
e.Install 3 volt battery. (To prevent damage to transmitter, remove the battery if not used for a long time).
f. Store the transmitter away from excessive heat or humidity.
g.This remote control unit is equipped with roll code combinations. In order to prevent possible
interference from or to other remote units such as garage door openers, car alarm or security system.
If you find that your fan and light kit go on and off without using your remote control, simply change the code
combination in your transmitter and receiver
Remote controller
INSTRUCTION OF INSTALLATION AND OPERATION
Use wire connecting nuts supplied with the fan
FIG.3
(
)
WHITE
RED or BLACK
INPUT
OUTPUT
PURPLE
BLUE
CANOPY
purple
black
grey
orange
yellow
white
pur ple
bla ck
whi te
ora nge
yel low
gre y
CODE
OUTPUT
COM
CODE
LEARN
TRANSMITTER
CAUTION:Ceiling Angle Shall Not Exceed 30 Degrees,For Mounting Controller,Model:RE-028W
CONNECT
TO
Green fan wire ....Bare supply wire
Red or Black receiver wire(AC IN L) ....Red or Black supply wire
White receiver wire(AC IN N) ....White supply wire
White receiver wire(TO MOTOR N) ....White fan wire
Black receiver wire(TO MOTOR L) ....Black fan wire
Blue receiver wire(FOR LIGHT) ....Blue light wire
Purple receiver wire(FOR REV) ....Purple rev wire
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
F4723-SMART
LIGHT
FAN
COM
REV
ANT
INPUT
RECEIVER
FIG.1
ACN
ACL
RECEIVER
( FIG.4 )
CANOPY
Publicidad
