Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Voltage and Frequency
Rated Power
Water Tank Capacity
Steam Volume
PARTS IDENTIFICATION
1.
Temperature Control Dial
2.
Burst of Steam Button
3.
Spray Button
4.
Spray Nozzle
5.
Water Inlet
6.
Water Tank
7.
Steam Control Knob
8.
Skirt
9.
Sole Plate
10. Up Cover
Notes:
• Some parts of the iron have been slightly greased, and as a result, the iron may smoke
slightly when switched on for the first time. It will not happen again after a few uses.
•
Before using the iron for the first time:
o Remove any protective films or stickers from the Sole Plate and the
plastic housing
o Clean the Sole Plate with a soft cloth.
o Test the iron on an old piece of fabric to ensure that the Sole Plate and
Water Tank are completely clean.
IRONING
Important: Read the section entitled "Important Safeguards" before proceeding.
CHOICE OF WATER
• This iron can be used with normal tap water. If the water in your area is particularly hard,
it is advisable to use distilled or demineralized water.
• Do not use chemically descaled water or any other liquids for refilling.
FILLING THE WATER TANK
• Ensure the iron is unplugged from the wall outlet and wait for the iron to cool down.
• Set the Steam Control Knob (7) to "0" and the Temperature Control Dial (1) to "OFF".
• Pour water into the Water Inlet (5) no higher than the maximum level "MAX" of the water
tank.
120V~60Hz
1200W
160ml
10-15g
2
7
5
4
10
3
1
3
6
8
9
Publicidad
