imilab EC3 Lite Manual Del Usuario página 6

Connecting the Device
Turn on the camera
Insert the power supply cable into the camera's power supply port.
Connect the other end of the power supply cable to a power source.
Indicator Light
Steady blue on: connected/device status is normal
Flashing blue: network error
Flashing orange rapidly: waiting for connection
Flashing orange slowly: system upgrade in progress
Insert a micro SD card
Ensure that the camera is disconnected from the power supply. Use
a screwdriver to remove the protective case and expose the micro
SD card slot. The contact points of the micro SD card should be
facing the same direction as the camera. Insert the micro SD card
into the slot.
Note:When inserting or removing the micro SD card, please disconnect the camera
from the power supply. Please use a micro SD card from a reputable manufacturer.
The recommended read and write speed of the micro SD card is at least U1/Class 10.
Restoring factory settings
Press and hold the reset hole with fine needle, then you can hear the
"reset succeed" voice. Data stored on the MicroSD card is not
deleted.
EN-04