Descargar Imprimir esta página

Hinkley SCULPT Manual De Instrucciones página 8

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

HANGING THE FAN
Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove cross pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its pulp packing with
2
the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the downrod
3
pin and cotter clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable
4
from the fan through the downrod. Thread downrod into
coupler until holes align. Insert downrod pin through holes
in mounting collar and downrod; clip cotter pin through
small hole in end of downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
| hinkley.com
06
Hanger
ball
Fig. 1
Lead wires
Mounting collar
Downrod pin
Fig. 2
Cross pin
Set screw
Downrod
Safety cable
Downrod
Security screws
Cotter pin

Publicidad

loading

Este manual también es adecuado para:

Swell 903856fbb-ldd