Descargar Imprimir esta página

Beta 3910 Manual De Uso E Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
OPERATION MANUAL AND INSTRUCTIONS
ISTRUZIONI PER L'USO
Mechanical clamping and adjustment of the workbench
Before starting to use the workbench, make sure that it rests stably on the floor by adjusting the four feet of the support structure.
PRINCIPLE OF OPERATION
The workbench has been designed and manufacturer to allow a single operator to secure a bicycle to the platform and
subsequently move it manually.
Secure the bike to at least 2 of the 3 available fixing points:
• Front fixing point; (to be used ALWAYS);
• Central telescopic support point;
• Rear fixing point.
The front fixing point must ALWAYS be used to secure the bicycle to the workbench. Once the bicycle is securely secured to the
front fixing point with the platform in lowered position, the platform can then be raised. By operating the brake piston release lever,
applying an upward force to the handle and activating the support pedal, the platform will rise to the desired position and lock
when the brake lever is released. The bicycle can now be secured to at least one of the other two fixing points.
The central telescopic support point and the rear telescopic fixing point must ALWAYS be used along with the front fixing
point. The central telescopic support and rear telescopic fixing point must be used with the front fixing point either together or
individually. The bike must NEVER be secured using the central telescopic support and the rear telescopic fixing point alone.
When you have finished working on the bike, release it from its rear and/or central fixing point and return the workbench to
the lowered position. To do this, use the piston brake release lever and, using the handle and support pedal, accompany the
workbench until it is fully lowered. Only now will it be possible to fully release the bike and remove it from the workbench.
The procedure for the correct use of the workbench is described in this manual.
To operate the workbench, just one operator must be present during all the platform moving and bicycle securing stages.
DESCRIPTION OF THE WORKBENCH
Main Components
The following figures show the main components of the workbench:
1) Support frame and lifting system
2) Platform
3) Bicycle lifting ramp
4) Lifting handle
5) Brake piston release lever
6) Lifting support pedal
7) Front securing frame
8) Direct fork fixing crossbar
9) Central telescopic unit
10) Rear insert
11) Handlebar support
12) Spring clamp
13) Clamping levers
Figure 1: Shot peened maintenance bench
10
EN
I

Publicidad

loading