Aqua Medic Blenny Qube Manual De Instrucciones página 4

Ocultar thumbs Ver también para Blenny Qube:

Idiomas disponibles

Operation Manual ENG

The saltwater aquarium Blenny Qube is a nano aquarium incl. skimmer, filtration and lighting.

1. Product description

Following parts are included:

- Aquarium 40 x 50 (incl. filter chamber) x 40 cm

- Skimmer EVO 501

- Current pump EcoDrift 4.3

- Illumination Qube 50

- Filter separating wall

- Filter basket for taking up activated carbon or phosphate absorbers

A timer and a socket board are not included.

2. Set-Up of the aquarium

The aquarium can be placed directly on a sufficiently solid cabinet or desk. Before setting up the aquarium, please

make sure that the load-bearing capacity of the base is sufficient for the filled system as a whole. The floor must

be firm and level. It must not give under pressure. The contact surface between the glass base and the surface

of the base cabinet must be free of any kind of dirt. The use of a mat between the glass base and base cabinet

is expressly not recommended.

First of all, the aquarium has to be cleaned with clear water. Afterwards, the protective plastic film has to be

pulled off the black plastic rear wall (if applicable). The lower edge of the rear wall has a lip made of self-adhesive

foam rubber. Wipe any fingerprints off the lower edge by using a dry cloth. Remove the protective plastic film

from the self-adhesive strip, apply and remove any excess rubber. Now, push the rear wall into place.

3. Current pump EcoDrift 4.3

See attached manual.

The pump is open at the front. Therefore, it should never be started uncontrolled. Animals could be

found in the sucking in basket and they could be injured or killed by the starting propeller. The pump has to be

adjusted in such a way that the water level in the filter chamber is not greatly reduced or fluctuates.

Otherwise, the skimming process is not working.

The pump is attached to the filter separating wall by using the magnetic holder, so that the outflow opening

extends into the recess of the separating wall (see Fig. 1).

Fig. 1: Mounting the EcoDrift 4.3