Publicidad
Pre-Assembly
ti
Using the easy driver (DD), secure the back-to- roof retainers (L) to the rear back panel (I) with one easy bolt each (EE) as shown. DO NOT over tighten.
This product uses self-tapping screws in some areas. There are no pre- drilled holes. Use force when
starting to drive the screw. Once the screw pierces the plastic it will drive easier.
Position the rear roof panel (I) with the smooth side facing down. Using four screws (CC), secure the rear roof bar support (T) to the rear roof panel as shown.
10
Publicidad
