Publicidad
Idiomas disponibles
Idiomas disponibles
The fitted ventilator sucks in the air that is required for the liquefaction of the cooling agent and
cooling the compressor on the long side of the equipment and presses it out again on the top
side.
Hold the refrigerating tongs upright and switch the system on for about 5 minutes so that any
oil that may still possibly be in the refrigerating tongs can find its way back into the circuit.
Switch on by operating the rocker switch.
Caution: During the freezing process make sure that all
the air grilles are not blocked as proper air circulation must
be guaranteed!
The ROFROST Turbo R290 is a "contact freezing unit". The function of the unit can only be
guaranteed if there is proper heat-conducting contact between the refrigerating tongs and the
pipes that are to be frozen. Paint and contamination in the application range of the tongs will ex-
tend freezing times; ideally, the pipe to be frozen should be metallic bright.
Only apply the refrigerating tongs to the straight pipe sections. Badly distorted or out-of-
centre pipes are not suitable for freezing.
4.2
Application and replacement of the tools
The refrigerating tongs are designed for pipes with an exterior diameter of:
ROFROST Turbo R290 1.1/4":
ROFROST Turbo R290 2":
Special reducing inserts are required in order to also be able to freeze pipes of a smaller diame-
ter (see ill. A or B).
Spread heat-conducting paste generously on the contact surfaces between the refrigerating
tongs, reducing inserts and pipes to avoid insulation bridges (see ill. C-1).
Caution: Heat-conducting paste must be used for optimal
function! Important information: The refrigerating tongs and
pipes must be protected against draughts during the freez-
ing process!
Handle the reducing inserts and refrigerating tongs with care. Clean them with a dry cloth af-
ter use and store them in the lining provided to protect them against damage.
4.3
Operating
The ROFROST Turbo R290 is a compact ready-to-plug unit. It works with a hermitical compres-
sion refrigerating system. Troublefree continuous operation for hours or days is possible under
supervision and within the prescribed ambient temperature range and voltage / frequency in ac-
cordance with the technical data.
The simple clamping system of the refrigerating tongs ensures safe fastening to the pipe.
Press the gripper together with the appropriate insert onto the pipe to be frozen and tighten
by means of the fastening screw (see ill. C-2).
Caution: Only tighten the fastening screw by hand!
Remove superfluous heat-conducting paste!
We recommend greasing the screw as this makes it easier to release the refrigerating tongs af-
ter the freezing process!
Important information: During the freezing process a temperature difference between display
(L) and display (R) is possible. As a rule, however, this is compensated for in the minus range.
Furthermore, exterior factors can also play a part, e.g:
–
Different output temperatures of the respective pipes due for freezing,
–
Different pipe diameters,
42 mm / 1¼" respectively
54 mm / 2" respectively.
ENGLISH
17
Publicidad
