Pahlen Jet Swim Athlete Manual De Instrucciones página 14

Jet Swim Athlete
Installation
Mount the pump part on a firm surface in a dry space.
Ensure that the space has good ventilation and is provided with drains to prevent flooding.
All mounting of stainless-steel parts shall be carried out with tools intended solely for the respective material to maintain
corrosion resistance. All screws should be greased with Molykote® (supplied).
Note!
The starter hose must always be laid in a loop 150–200 mm above the water surface.
Never run the pump dry as this will damage the shaft seal.
Electrical installation must be carried out by a qualified electrician and fitted with a residual current device.
1. Installation for thin pool wall with liner
(wood, sheet metal, plastic, etc.)
22
7
12 8
11
10
9 6
5
1. Make a hole (approx. 457x144 mm) in the pool wall for the enclosure (item 1).
Use the enclosure as a template: mark and drill the four holes on the sides (drill Ø6).
2. Place the enclosure in the hole with the flanges facing the outside of the pool body.
Install with screws (item 2), washers (item 3) and nuts (item 4).
3. Attach the self-adhesive gasket (item 5) to the enclosure.
4. Mount the wall mat and liner.
5. Fill the pool with water up to 5 cm below the enclosure.
6. Screw (item 8) the fastening frame (item 7) with the rubber gasket (item 6) under-
neath the enclosure with 5 Nm in tightening torque. The screws must be greased.
7. Cut off the liner against the inside of the clamping frame.
8. Fit the inlet grille (item 10) and the stainless-steel front (item 11) with the screws
(item 11) to be greased.
9. Mount the starter hose, see section "Installing the starter hose" on page 13.
10. Connect the pump (item 19) with the supplied hose socket (item 16), hose (item
17) and hose clamps (item 18). The pool can then be filled with water to the desired
level.
11. Electrical connection must be carried out by a qualified electrical installer, see sec-
tion "Electrical installation".
NOTE! The pump must never run without water.
21
20
13
14
1
4
3
2
14
15
17
18
16
19
Figure 5.
Wooden frame with liner, as seen from above.
1. Niche
2. Coundersunk screw M6x30 (4 pcs)
3. Washer (4 pcs)
4. Nut (4 pcs)
5. Self-adhesive gasket
6. Packing
7. Mounting frame
8. Coundersunk screw M5x16 (24 pcs)
9. Screw M4x10 (8 pcs)
10. Inlet grille (3 parts)
11. Front
Surface treatment
E
12. Coundersunk screw M5x20 (2 pcs)
The tolerance class in accordance with this
13. O-ring
part of ISO 2768-1
14. Plug
15. Starter hose (two parts)
16. Hose socket (2 pcs)
17. Hose (2 pcs)
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
18. Hose clamp (4 pcs)
19. Pump
20. Pool body (plywood)
21. Wall mat
22. Liner
ENGLISH
Designed by: Drawn b
RJ
Assembly drawing no. Art.no.
Scale
Drawing
plywoo