Publicidad
Idiomas disponibles
Idiomas disponibles
Parts & Features
See figures below for reference.
Quick Connect
Offers a quick release feature for
attaching and removing the air hose.
Regulator Gauge
Indicates the outgoing air pressure
to the tool and is controlled by
the regulator.
Pressure Relief Tube
Check Valve
When the pump is not in operation the valve closes to retain air
pressure inside the tank. An internal component.
Regulator
The air pressure coming from the air tank is controlled by the
regulator. To increase the pressure turn the knob clockwise and to
decrease the pressure turn the knob counterclockwise.
Pressure Relief Valve
The pressure relief valve located on the side of the pressure
switch, is designed to automatically release compressed air
when the air compressor reaches cut-out pressure. The
released air should only escape momentarily and the valve
should then close.
Pressure Switch
This controls the power to the motor and also the cut-in/
cut-out pressure settings. This switch serves as the
Auto/Off positions for the unit.
Tank Pressure Gauge
Indicates the reserve air pressure in the tank.
Air Intake Filter
Provides clean air to the pump and must
always be kept free of debris. Check on a
daily basis or before each use.
Tank Safety Valve
Tank Drain Valve
Used to drain condensation from the air tank.
Located at bottom of tank.
3
Used to allow excess tank pressure to escape
into the atmosphere. This valve should only
open when the tank pressure is above the
maximum rated pressure.
Oil Fill Cap
Oil Sight Gauge
Outlet Tube
Publicidad
