Publicidad
Idiomas disponibles
Idiomas disponibles
ing unit from dolly
For removing, read steps below first before attempting to remove or replace the air compressor to the dolly:
Do not use the dolly for any other means other than transporting this aur compressor.
Do not move air compressor/dolly
combo without tightening the knob that safely secures the compressor to the dolly.
Removing
the air compressor
from the doily:
1. The air compressor should be turned off and
unplugged from the power source.
2. Turn the knob on the bottom of the dolly counter°
clockwise until the knob releases from the air
compressor. (This should be 1°2 revolutions)
3. While holding the dolly cart handle with one hand,
rift up on the air compressor handle to remove the
compressor.
%
Reattaching
the air compressor
to the dolly:
1, The air compressor should be turned off and
unplugged from the power source.
2. Align the compressor's
rubber isolators with the
depressions in the dolly frame.
3. insert knob bolt into the air compressor and rotate
clock°wise until tight. (if the compressor is not properly
aligned onto the frame the knob will not tighten.
Reposition compressor and try again.)
NOTE:
Any service procedure
not covered
in the
maintenance
schedule
should
be performed
by
qualified
service personnel.
The air compressor
should be turned off, unplugged
from the power source,
air bled from the tank and
allowed
time to cool
before
any
maintenance
is
performed.
To ensure
efficient operation
and longer life of the
air compressor
unit, a routine maintenance
schedule
should be followed.
The following schedule is geared
toward a consumer
whose compressor
is used in a
normal working environment
on a daily basis.
Items to Check/Change
Check Tank Safety Valve
Overall Unit Visual Check
Check Air Filter
Drain Tank
Check Power Cord for Damage
Change Oil
Check Oil Level
Before each use
or daity
X
X
X
X
X
after first 50 hours
after every 100 hours
X
Storage
For storing the air compressor, be sure to do the following:
1. Turn the unit off and unplug the power cord from the
receptacle.
2. Remove all air hoses, accessories, and air tools from
the air compressor.
3. Perform the daily maintenance
schedule.
4. Open the drain valve to bleed all air from the tank.
5. Close the drain valve.
6. Store the air compressor in a clean and dry location.
Publicidad
