TO OPERATE MOWER
Your tractor is equipped with an operator
presence
sensing
switch.
Any attempt
by the operator to leave the seat with the
engine running and the attachment
clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating or
cutting off when operating your equipment
on rough, rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
TO STOP MOWER BLADES
Disengage attachment clutch control.
_,CAUTION:
Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector shield
in place.
REVERSE OPERATION SYSTEM (ROS)
Your tractor is equipped with a Reverse
Operation System (ROS). Any attempt by
the operator to travel in the reverse direction
with the attachment clutch engaged will shut
off the engine unless ignition key is placed
in the ROS "ON" position.
AI_WARNING:
Backing
up with the at-
tachment clutch engaged while mowing is
strongly discouraged. Turning the ROS "ON",
to allow reverse operation with the attach-
ment clutch engaged, should only be done
when the operator decides it is necessary to
reposition the machine with the attachment
engaged. Do not mow in reverse unless
absolutely
necessary.
USING
THE
REVERSE
OPERATION
SYSTEM -
Only use if you are certain no children or
other bystanders will enter the mowing area.
1. Depress clutch/brake
pedal all the way
down and hold.
2. With engine running, turn ignition key
counterclockwise
to ROS "ON" position.
3. Look down and behind before and while
backing.
4. Move gear shift lever to reverse
(R)
position and slowly release clutch/brake
pedal to start movement.
5. When
use of the ROS is no longer
needed, turn the ignition key clockwise
to engine "ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE ON HILLS
_WARNING:
Do not drive up or down
hills with slopes greater than 15° and do
not drive across any slope. Use the slope
guide provided at the back of this manual.
* Choose the slowest speed before starting
up or down hills.
* Avoid stopping or changing speed on hills.
* If stopping is absolutely necessary, push
clutch/brake pedal quickly to brake posi-
tion and engage parking brake.
* Move gearshift lever to 1st gear. Ensure
you have allowed room for tractor to roll
slightly as you restart movement.
* To restart movement, slowly release park-
ing brake and clutch/brake pedal.
* Make all turns slowly.
13