Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
WARNING:
Do not short battery termi-
nals by allowing a wrench or any other object
to contact both terminals at the same time.
Before connecting
battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hood to raised position.
2. Remove terminal cover.
3. Disconnect
BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
4. Install new battery with terminals in same
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect
BLACK
grounding
cable to
negative (-) battery terminal with remain-
ing bolt and nut. Tighten securely
8. Close hood.
__-],
Negative
_, _
..._IV "
_
S
'1 /
(Black)
__
Cable
Cover
(Red) f
_
%(_-J_
//
Cable
\___
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
iNTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
* Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD & GRILLASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides and slide left removing hood from
pivot pins and lift hood off of tractor.
4. When replacing hood, ensure to recon-
nect the headlight wire connector.
/_
,
_Hood
__
;__
?__°tPinpivetPin
©
Headlight Wire Connector
ENGINE
TO ADJUST THROTTLE
CONTROL
CABLE
The throttle
control
has been preset at
the factory and adjustment
should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment is necessary, see engine
manual.
26
Publicidad
