Publicidad
Idiomas disponibles
Idiomas disponibles
Installing or removing bit
Clean the shank end of the bit and apply grease before
installing the bit.
2
Fig.7
► 1 . Shank end 2. Grease
Insert the bit into the tool. Turn the bit and push it in until
it engages. After installing the bit, always make sure
that the bit is securely held in place by trying to pull it
out.
1
Fig.8
► 1 . Bit
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
2
Fig.9
► 1 . Bit 2. Chuck cover
1
1
8 ENGLISH
Bit angle
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring forward,
then turn the change ring to change the bit angle. At the
desired angle, slide the change ring back to the original
position. The bit will be secured in place.
1
Fig.10
► 1 . Change ring
Hook
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
Using the hook
The hook is convenient for temporarily hanging the tool.
To use the hook, simply lift up hook until it snaps into
the open position. When not in use, always lower hook
until it snaps into the closed position.
Fig.11
► 1 . Hook
1
Publicidad
