Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3
004782
OPERATION
Pre-lubrication
Coat the cutting line with machine oil to increase the
punch and die service life. This is particularly important
when cutting aluminum.
Cutting method
013285
Hold the tool so that the cutting head is at a right angle
(90°) to the workpiece being cut. Move the tool gently in
the cutting direction.
Cutouts
013286
Cutouts can be done by first opening a round hole over
21 mm (13/16") in diameter which the cutting head can
be inserted into.
1. Bolts
2. Die
4
3. Punch
4. Die holder
Cutting the corrugated or trapezoidal sheet
metals
3
4
1. From the top view
2. Cutting at an angle to grooves
3. Cutting perpendicular to grooves
4. From the side view
5. Corrugated or trapezoidal sheet metal
013280
Set the die position so that the die faces the cutting
direction
either
when
perpendicular go grooves in corrugated or trapezoidal
sheet metals.
1
2
004791
Always hold the tool body parallel to the grooves with
the cutting head at a right angle (90°) to the cutting
surface as shown in the figure.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
7
1
2
5
cutting
at
an
1. From the side
view
2. Cutting head
should be at a
right angle
(90 ﾟ) to cutting
surface.
angle
or
Publicidad
Tabla de contenido
