Publicidad
5. Push the L joint into the end of the
two frames (one short and one long)
6. Connect all four frames together
7. Lay out the screen and tension rods on a clean surface. Insert the tension
rods through the sleeves according to their corresponding lengths on each
edge of the screen
PUSH
rod
Screen
horizontal
rod
8. The back of nished aluminum frame is up to put on the clean ground.
The black back of screen is up to put on the aluminum frame, then the location
of tensioner are the corresponding with the location of hole on the fabric.
9. Use the L bracket to cover the corner of the screen and locate the screw holes
on the L joint and fasten the four corners by using the L joint screws included.
-2-
img. C
img. D
img. E
Screen
img. F
img. G
Note: After all assembled, Please check the screen's level, if there are any ripples, please
adjust the location of corresponding tensioners at back until the ripples disappear.
Installation on Drywall: 1. Locate your desire installation location with a stud nder
(recommended) and mark the drill-hole area of where the screen is to be installed.
2. Drill a hole with the proper bit size according to the drywall anchor included.
3. Line up the wall bracket with the drilled holes on the installation location and screw
(drywall screw) them in using a screwdriver.
4. Position the xed frame screen onto the top wall brackets.
CAUTION: Please follow this instruction carefully to ensure proper maintenance
and safety with your screen: 1. When hanging the screen up, please make sure that
no other objects such as power switches, outlets, furniture, ladders, windows, etc.
Occupy the space designated for your xed frame wall screen.
2. Regardless if the screen is hung on or installed into the wall, make sure that the proper
mounting anchors are used and that the weight is supported appropriately by a strong
and structurally sound surface just as any large and heavy picture frame should.
3. Frame parts are made of high quality velour-surfaced aluminum and should
be handled with care. 4. When cleaning, use a damp soft cloth with warm water to
remove any marks on the frame or screen surface. 5. Never attemptto use any solutions,
chemicals or abrasive cleaners on the screen surface.
PL I Ścienny ekran projekcyjny Instrukcja obsługi
Dziękujemy za zakup naszego ekranu projekcyjnego. Ekran wykorzystuje bardzo
dobrej jakości materiał oraz stałą oprawę aby zapewnić Ci prawdziwą radość z kina
domowego. Proszę poświęcić chwilę na zapoznanie się z instrukcją instalacji, aby
uniknąć wszelkich potencjalnych problemów.
Uwagi dotyczące instalacji: 1. Montaż wymaga udziału 2 osób; przestrzeń do
montażu musi być większa niż rozmiar ekranu. 2. Upewnij się, że miejsce pracy jest
czyste i wolne od zanieczyszczeń. 3. Ekran należy trzymać z dala od wysokich
temperatur, aby uniknąć trwałego odkształcenia materiału.
Lista części:
• Napinacze
• Śruby do łącznika L(x16) • Łącznik L (x4)
• Uchwyt L (x4)
• Kołki (x4)
• Śruby do kołków (x4)
• Uchwyty ścienne (x4)
• Rama długa/krótka (x4) • Pręty naciągowe długie/krótkie (x4)
img. H
• Podkładki (x4)
• Tkanina ekranu (x1)
-3-
Publicidad
