Publicidad
Idiomas disponibles
Idiomas disponibles
.
Plug electrical power cord into an electrical circuit rated
for 120 Volts AC at 15 Amps that is properly installed
and grounded in accordance with all local codes and
ordinances. The indicator light on the GFCIshould appear.
NOTICE The indicator light must be visible for the electric
pressure washer to operate.
8. Press TEST button (B). The indicator light (D) should
disappear.
Howto Stop YourElectricPressureWasher
The electric pressure washer motor runs only when the
trigger is engaged.To stop the electric pressure washer and
turn off the motor:
1. Releasespray gun trigger.
2. Press the master ON/OFFswitch to the OFF(0) center
position.
NOTICE Releasingthe trigger will shut off the motor but
does not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to relieve built up pressure in the unit.
A WARNING The high pressure stream of water that this
_
quipment produces could cut through skin and
its underlying tissues, resulting in serious injury
and possible amputation.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, squeeze
spray gun trigger to releasehigh pressure, every time
you turn off pressure washer.
9. Press RESETbutton (6). The indicator light (D) should
illuminate.
NOTICE DO NOT use the electric pressure washer if above
test fails.
10. Press the master ON/OFF switch to the Pressure Washer
ON position (-).
11. Point gun in a safe direction, press trigger lock button
and squeezetrigger. The electric pressure washer motor
will start and stop as spray gun trigger is depressed and
released.
The electric pressure washer is now ready for use.
Instructions for use of the supplied accessories are given
later in this section.
5. Disconnect GFCIplug from outlet and coil power cord.
6. Flush detergent tank (if used) by removing it from the
pressure washer and pouring out all remaining solution.
7. Rinse detergent tank out with fresh clean water and
reinstall onto pressure washer.
8. Coil and store power cord, high pressure hose, spray gun
and accessories on the accessory tray.
Howto Usethe Spray Tips
You should now be familiar with how to STARTand STOP
your electric pressure washer. If not, please refer to the
previous section to familiarize yourself with STARTINGand
STOPPINGthe system before continuing.
The quick-connect on the metal wand allows you to switch
between three different quick connect spray tips. Spray tips
can be changed while pressure washer is running once spray
gun trigger lock is engaged. The spray tips vary the spray
pattern as shown.
11
Publicidad
