5
CASTERS INSTALLATION
(The picture does not exactly match the actual product, and is for reference only) Take out the
and install it with the casters as shown in the figure below.
INSTALL THE BASE ELBOW
The picture does not exactly match the actual product, and is only
for installation instructions reference)
Loosen the screw counterclockwise as shown in the figure until it is
loose (the nut does not fall).
Take out the round machine hexagon socket screw M8*25, flat wa-
φ
φ
sher
8, spring washer
8 from the screw package, first install the
screws on both sides of the riser, and finally install the screws on
one side of the riser.
1
φ
10 spring washer from the screw package
2
Install the inner tube downwards and match it with the base. After
the installation is completed, the inner tube is shaken back and
forth to facilitate screw installation.
Re tighten previously loosened M8*120 screws to complete the in-
stallation.
ENGLISH
φ
SPRING WASHER
10
3