Hinkley 80 SCULPT Manual De Instrucciones página 8

HANGING THE FAN
Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove cross pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its pulp packing with
2
the mounting collar (where the wires come out) facing
upward.
3 Loosen the two security set screws and remove the downrod
pin and cotter clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable
4
from the fan through the downrod. Thread downrod into
coupler until holes align. Insert downrod pin through holes
in mounting collar and downrod; clip cotter pin through
small hole in end of downrod pin to hold downrod in place.
5 Tighten security set screws against downrod using a large
flat blade screwdriver to ensure a tight fit against downrod.
06 | hinkley.com
Hanger
ball
Fig. 1
Lead wires
Mounting collar
Downrod pin
Fig. 2
Cross pin
Set screw
Downrod
Safety cable
Downrod
Security screws
Cotter pin